![]() SYS,"C:Program FilesANSYS Incv192ANSYSbinwin圆4Opti.exe" 53795 TOPO1 When I look at the ds.dat file it appears that all of the topo opt stuff is being handled by an APDL system command: The new Workbench Topo Opt doesn't seem to use any of those commands. You can find some of the old documentation.Īt some point, all of these commands became undocumented and were removed from the APDL GUI interface. TOPDEF would define some of the setup, TOPEXE would run a single step of topology optimization, and TOPITER would run a series of topo iterations.Īll of the constraints were controlled with a bunch of OP commands (OPADD, OPVAR, OPTYPE, OPFRST, etc). A long time back (probably v12.1 or so) the topology optimization commands were part of APDL but were very limited. I don't think there is any way to do this with APDL commands.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |